Description: 【Perfect Match】 Interchangeable OEM part number: 173-3536, 583340, 583536, 763767. Outboard Stator For Johnson Evinrude 2 Stroke 4 Cylinder 4 Cyl 9 Amp works on 1988-1998 Cross Flow engines: 65 JET, 80 JET, 85HP, 88HP, 90HP, 100HP, 112HP and 115 HP.【Fix Spark Issues】 Fix significant power drop caused by defective outboard stator, such as no spark, weak spark, or intermittent spark, etc. Any sign of leakage out of the high voltage coils or bubbling around the battery charge windings indicate a bad stator. If you are planning to do a stator upgrade for your boat, this outboard stator is a must-have item.【Superior Material】 Made of corrosion resistant copper and steel materials to cope with wet and harsh operating environments. The upgraded open stator has better cooling effect compared to the original sealed stator. Pure copper wire with all copper tinned core, anti-aging, greatly improves performance and durability.【Premium Quality】 Direct replacement parts are designed, engineered and tested in accordance with strict standards. Give you the peace of mind that the fit, form, and function is up to the high standards and specifications of Johnson Evinrude Stator.【Warm Tips】 1) Please kindly check the interchangeable part number and compatible models before purchasing. 2) Please do troubleshooting before buying the replacement part. Fix Spark IssuesFix significant power drop caused by defective outboard statorSuch as no spark, weak spark, or intermittent spark, etc.Superior MaterialMade of corrosion resistant copper and steel materials to cope with wet and harsh operating environments.Pure copper wire with all copper tinned core, anti-aging, greatly improves performance and durability.The upgraded open stator has better cooling effect compared to the original sealed stator.Give you the peace of mind that the fit, form, and function is up to the high standards and specifications of Johnson Evinrude Stator.Perfect MatchInterchangeable OEM part number: 173-3536, 583340, 583536, 763767.Outboard Stator For Johnson Evinrude 2 Stroke 4 Cylinder 4 Cyl 9 Amp works on 1988-1998 Cross Flow engines: 65 JET, 80 JET, 85HP, 88HP, 90HP, 100HP, 112HP and 115 HP.Installation Tips:1. Remove the negative battery cable.2. Remove the flywheel.3. Disconnect the original stator wires.4. Remove the original stator, saving the original bolts.5. Install the new stator using the original bolts with a good thread-locker applied (CDI 989-3977 is recommended) tothe bolts and tightened to the factory torque specifications.6. Connect the new stator to the power pack.7. Connect the new stator to the regulator/rectifier (ignore any stripes on the rectifier as the new stator does not requirethe Yellow wires to be connected to a particular rectifier wire).8. Replace the flywheel according to the service manual.9. Clean all battery cable connections, both on the battery and the engine.10. Replace the battery cable.Troubleshooting the StatorNOTICE: Any sign of leakage out of the high voltage coils or bubbling around the battery charge windings indicate a bad stator. Check for burned marks on each pole. If a problem is found on the battery windings, we recommend the rectifier/regulator be closely checked or replaced.No spark on any cylinder:1. Disconnect the stop (kill) wire and retest. If the ignition now has spark, check the stop circuit.2. Check resistance between the Brown/Yellow and the Brown wires. You should read approximately 450-600 ohms. DVA (peak voltage) should be 150v or more while connected to the power pack for each .3. Inspect the flywheel outer and trigger magnets to see if they are loose or broken.4. Disconnect the rectifier and retest. If the fire returns, replace the rectifier.No spark on One Bank:1. Swap the power packs from side to side and see if the problem moves. If it does, the power pack not sparking is likely bad.2. Check the trigger leads and compare the readings for both sides. The readings should be very close.3. Disconnect the stop wires and separate them. If the pack that had no spark now has spark, replace the pack that initially had spark.4. Check resistance between the Brown/Yellow and the Brown wires. You should read approximately 450-600 ohms. DVA (peakvoltage) should be 150v or more while connected to the power pack for each.High speed miss or weak hole shot:1. Connect DVA meter between the Brown/Yellow and the Brown wires and do a running test on each set. AT NO TIME SHOULD THE VOLTAGE EXCEED 400v. If it does, the regulator circuit in the power pack is bad. The voltage should show a smooth climb and stabilize, gradually falling off at high RPM (above 5000). If you see a sudden drop in voltage right before the miss becomes apparent, the problem is likely in the stator.2. Disconnect the rectifier and retest. If the problem disappears, replace the rectifier and retest.Overcharging1. Using a voltmeter, check the voltage on the battery and compare it to the voltage on the red wire connected to the starter solenoid to engine ground.2. If the voltage is high on the engine compared to the voltage on the battery, do a voltage drop test and try to isolate the area where the problem is.3. If the voltage is the same on the battery and the engine, but is over 15.5 volts at 4500 RPM, replace the battery with a known good high quality MARINE battery.4. A continued high voltage reading may indicate the need for a regulator/rectifier combination instead of a rectifier only. Payment method: We accept PayPal payment only. Contact us: If you meet any problem after receiving our product, please feel free to contact us. We will try our best to solve your problem. Shipping policy: Orders will be ship out within 1-2 business days after payment has cleared. Orders from Saturdays, Sundays or holidays will process on next business day and will be ship within 24 hours. Please allow 10-30 days for international deliveries. Some shipments could take longer subject to your local customs authorities. United states 2-5(days) Return & Warranty: 1.We accept 30 days return guarantee for all Items If you are unsatisfied with something you bought from us, you may send it back within 30 days of receipt, and we shall be happy to exchange or refund. 2.Leave a message note in returned box quoting your item(s) ID and buyer ID. 3.All returned products must be in their original condition and packaging. Unfortunately, if products have been assembled or modified, we cannot take them as returns. 4.It is important that we know when your return is expected. Please save your return tracking number or post receipt, and email it to us. We need this in case there are any issues during transit. 5.Refund will only be issued upon our receipt of the returned parcel. Please allow 2 working days for us to process with your return. About reply: If you have any questions, please feel free to email our service specialists 24 Hours a Day, 7 Days a Week, and we will reply you ASAP. If no response within 24 Hours, please check the spam of mail box or kindly re-send it to us. About Feedback: Please contact us before leaving Netural or Negative feedback if you are not satisfied our service or products. Good communication is helpful for both of us to resolve any problems and issues. We work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave positive feedback to all our customers. If you are satisfied with our service, please kindly leave us a 5-star feedback. Thanks!
Price: 97.99 USD
Location: Moreno Valley, California
End Time: 2024-12-15T09:44:01.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
Returns Accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: Unbranded
Warranty: 1 Year
Manufacturer Part Number: 583340/583536/763767/173-3536