Description: RatioMP282 (4) : MH283 (1)CompatabilityCan be top-coated with:MP17x Epoxy PrimerMP213 GP SealerMP23x 2K Urethane SealersMBP Omni Plus Acrylic Urethane BasecoatMBC Acrylic BasecoatMTK Acrylic Urethane Single StageMAE Acrylic EnamelMAE Acrylic Enamel with HardenerCan be applied over:Cleaned, sanded, and etch primed steel, galvanized, and aluminum.Sanded and cleaned body filler, SMC, and gel-coated fiberglass.Properly cleaned and sanded E-coat Cleaned, cured, and sanded OEM and refinished coatings.MP17x Epoxy PrimersMP176 Etch PrimerMP178 Plastic PrimerMP243 Polyester PrimerApplication2 - 3 coats1st Coat: Fully cover the roller by rolling it in the MP282 primer. Start from the center of the repair and roll the primer all the way out to the featheredge using a “flicking” or lifting technique that will create a feathered edge in the primer around the entire repair. This technique will ensure a thin, smooth edge and make the sanding of the featheredge much easier.2nd and 3rd Coats:When the first coat has thoroughly flashed for approximately 3 - 5 minutes, again start from the center and roll another coat just inside the edge of the first coat, using a featheredge ‘lifting’ technique. Note: Be sure to not allow the 2nd and 3rd coats to extend past the outside edge of the previous coat’s featheredge or solvent may be trapped resulting in shrinkage and may also generate a heavier edge than desired which will require excessive-finish sanding.Sanding:After an appropriate air dry or force cure, MP282 can be wet sanded with P400 followed by P600 or dry sanded with P360 followed by P500. After sanding, a minimum film build of 1.5 mils is recommended for optimum performance.
Price: 214.99 USD
Location: Wichita, Kansas
End Time: 2024-09-29T16:54:45.000Z
Shipping Cost: 8.88 USD
Product Images
Item Specifics
Returns Accepted: ReturnsNotAccepted
Return policy details:
Brand: PPG
Type: High Build 2k Primer-Surfacer
Warranty: No Warranty
Items Included: Activator/Hardener, Primer
Manufacturer Part Number: MP282
